ISO 10300-3:2023

International Standard   Current Edition
· Approved on 24 August 2023 ·

Calculation of load capacity of bevel gears — Part 3: Calculation of tooth root strength

ISO 10300-3:2023 Files

null Pages
Current Edition

ISO 10300-3:2023 Scope

This document specifies the fundamental formulae for use in the tooth root stress calculation of straight and helical (skew), Zerol and spiral bevel gears including hypoid gears, with a minimum rim thickness under the root of 3,5 mmn. All load influences on tooth root stress are included, insofar as they are the result of load transmitted by the gearing and able to be evaluated quantitatively. Stresses, such as those caused by the shrink fitting of gear rims, which are superposed on stresses due to tooth loading, are intended to be considered in the calculation of the tooth root stress, σF, or the permissible tooth root stress σFP. This document is not applicable in the assessment of tooth flank fracture.

The formulae in this document are based on virtual cylindrical gears and restricted to bevel gears whose virtual cylindrical gears have transverse contact ratios of ε < 2. The results are valid within the range of the applied factors as specified in ISO 10300-1. The bending strength formulae are applicable to fractures at the tooth fillet, but not to those on the active flank surfaces, to failures of the gear rim or of the gear blank through the web and hub.

This document does not apply to stress levels above those permitted for 103 cycles, as stresses in that range can exceed the elastic limit of the gear tooth.

NOTE            This document is not applicable to bevel gears which have an inadequate contact pattern under load.

The user is cautioned that when the formulae are used for large average mean spiral angles (βm1 + βm2)/2 > 45°, for effective pressure angles αe > 30° and/or for large facewidths b > 13 mmn, the calculated results of this document should be confirmed by experience.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013 
Bahraini Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-1:2015
GSO 150-1:2013 
Bahraini Technical Regulation
Expiration dates for food products -Part 1 : Mandatory expiration dates
GSO 150-1:2013
 
Gulf Technical Regulation
Expiration dates for food products -Part 1 : Mandatory expiration dates

Recently Published

ISO 16961:2024
 
International Standard
Oil and gas industries including lower carbon energy — Internal coating and lining of steel storage tanks
ISO 8643:2024
 
International Standard
Earth-moving machinery — Hydraulic excavator and backhoe loader lowering control device — Requirements and tests
ISO 11890-1:2024
 
International Standard
Paints and varnishes — Determination of volatile organic compounds (VOC) and/or semi volatile organic compounds (SVOC) content — Part 1: Gravimetric method for VOC determination
ISO/TR 18228-10:2024
 
International Standard
Design using geosynthetics — Part 10: Asphalt pavements